Skip to content

3‐1. addingdeleting areas, devices, and connections

Jump to bottom
Yusuke Ogawa edited this page May 10, 2025 · 2 revisions

⚠️ Note

Currently, when a wiring is changed, the existing wiring information cannot be fully tracked. For example, when a wiring is changed, it is not possible to determine whether the original wiring is maintained or a new wiring is made. Therefore, after a change in wiring, the new wiring should be compared to the previous wiring and reconfigured to the correct state.

1743771512574-eb78e4e5-49d2-4f43-98a5-c7528d98037e addingdeleting areas, devices, and connections_1 1743771512574-eb78e4e5-49d2-4f43-98a5-c7528d98037e addingdeleting areas, devices, and connections_2 1743771512574-eb78e4e5-49d2-4f43-98a5-c7528d98037e addingdeleting areas, devices, and connections_3 1743771512574-eb78e4e5-49d2-4f43-98a5-c7528d98037e addingdeleting areas, devices, and connections_4 1743771512574-eb78e4e5-49d2-4f43-98a5-c7528d98037e addingdeleting areas, devices, and connections_5

Author

  • Yusuke Ogawa - Security Architect, Cisco | CCIE#17583

License

SPDX-License-Identifier: Apache-2.0

Copyright 2023 Cisco Systems, Inc. and its affiliates

Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at

http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

Clone this wiki locally