Skip to content

6 1. Generation of VPN Diagram

Jump to bottom
Yusuke Ogawa edited this page Apr 14, 2025 · 1 revision

What you can do with this procedure

  • Load master data into Network Sketcher and generate VPN configuration diagram image

Procedure

  • Launch Network Sketcher
  1. Drag and drop the master file to the Main Panel
  2. The Master Panel appears. Click "VPNs on L1" under "Create the VPN diagram file image

  • "VPNs on L3” has been added since Ver 2.3.2.
    image image

    • VPNs on L3 VPN's segment will turn red when the IP address is set
    • VPN color has changed to purple since Ver 2.5.0

Author

  • Yusuke Ogawa - Security Architect, Cisco | CCIE#17583

License

SPDX-License-Identifier: Apache-2.0

Copyright 2023 Cisco Systems, Inc. and its affiliates

Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at

http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.

Clone this wiki locally